Crate from a

It is necessary to cut the beam of the overlap into the top beam of the strapping (it should be borne in mind that the board will be laid horizontally). The second boards are perpendicular to the first board. It is necessary to connect from each other using nails or screws. At the end the T-shaped beam of the ceiling should form. And then on this beam you need to install sites (horizontal and inclined). At the bottom of the floor, you need to make the ceiling (binder). The material for performing the ceiling can be selected any (lining, rogue, inch or trimming board). To protect the overlap from flowing water and precipitation, you need to make the second beam peeks out beyond the edge of the log house. The inclined plane must be made from the same board. Then the resulting ceiling must be covered with insulating material (for example, roofing material and pr.) and insulate (slag, expanded clay, etc.). On top of the entire area it is necessary to fill the crate from a non-strict board, and then be covered by roofing material in 3-4 layers and nail it.